References > Creo Schematics Installation and Administration Guide > Appendix > Installing Creo Schematics in Silent Mode > Editing the XML Files > Editing the QUALITY_AGENT Node
Editing the QUALITY_AGENT Node
The QUALITY_AGENT node represents the Diagnostic Tools settings for an installed Creo application. You can edit the following attribute of the QUALITY_AGENT node:
Attribute
Value
enable
Enables or disables the diagnostic reporting for a Creo application. For example, if this attribute is set to Y, diagnostic reporting is enabled.
* 
If the required attribute is set to Y, you must not change the value of the enable attribute to N. If you do so, the Creo Schematics application will not run because of conflicting settings.
A sample QUALITY_AGENT node in an XML file is as shown:
<QUALITY_AGENT enable="Y" keyname="QualityAgentOptIn" required="N"/>