Sheetmetal > Setting Up Sheetmetal Design > Bend Order > To Create or Edit a Bend Order Sequence
  
To Create or Edit a Bend Order Sequence
1. Click Model > Bends > Bend Order. The Bend Order dialog box opens.
 
* You can also access the Bend Order dialog box from the Model Properties dialog box.
2. To select a fixed geometry reference that is different from that of the part, click the Fixed geometry collector and choose a different reference.
3. To flip the fixed geometry to the other side of the edge, click Flip.
 
* The Flip command is available only when an edge between two nontangent surfaces is selected as a reference.
4. Click Add Bend and select a bend to add to the sequence.
5. Repeat step 5 until all required bends are added to the sequence.
6. To create a new bend order sequence, click Add Sequence and repeat steps 5 and 6 until all required bends are added to the sequence.
To define a fixed geometry reference different from the part fixed geometry reference, click the Sequence fixed geometry collector and choose a different reference.
7. To edit a bend order sequence, select a sequence from the list and then make any required changes.
8. Click OK.