Command
|
Description
|
Sets the start point the specified distance from an end of the selected segment. Drag the handle or type a value to specify the distance from the corner.
|
|
Sets the start point the specified length ratio from an end of the selected segment. Drag the handle or type a value to specify the ratio from the corner.
|
|
Sets the start point on the specified distance from the corner.
|
|
Sets the start point at the specified distance from a selected plane. Select a plane and type a value for the distance.
|
|
Sets the start point the specified distance from a fitting.
|
|
When you use the first two commands the following applies: • Click or to reference the opposite end of the pipe segment. When you use a fitting to set the location the following applies: • Click or to flip the reference port of the fitting. • You can select another fitting on the same pipeline for reference. • You cannot flip the placement location of an elbow fitting. |
Command
|
Description
|
Offsets from the centerline of the main pipe to the centerline of the branch pipe.
|
|
Offsets from the top or bottom of the main pipe to the top or bottom of the branch pipe.
|