Example: Parallel Pipe Piece Cutting
The following figure shows four parallel runs. The 100A-MS-STEAM-0001 pipe run has five pipe piece cuts: FW1, SW1, SW2, FW2, and FW3.
• To create cuts on the other three parallel pipe runs, click
Cut.
• Click
from the
Cut Pipe dialog box.
• Select the 100A-MS-STEAM-0001 pipe run as the reference pipe run because it contains the pipe piece cuts.
• Select the pipe runs that are parallel to the reference pipe run as target pipe runs for creating new cuts.
• Click OK to create the cuts.
Spec-Driven Piping creates cuts on the selected parallel target pipe runs at locations identical to locations on the reference pipe run as shown in the following figure.