Part Modeling > Engineering Features > Chamfer > Advanced Topics > Piece Management > To Trim Chamfer Geometry
  
To Trim Chamfer Geometry
1. Select the references for the chamfer and on the Model tab, click the arrow next to Chamfer, and click Edge Chamfer. The Edge Chamfer tab opens.
2. Click the Pieces tab and select the chamfer piece to trim from the Pieces table. Handles appear on the piece ends.
 
* If you have a closed-loop chamfer set, you need to open it by removing a patch. After you select the piece to trim, select a patch from the graphics window. The patch is removed, and handles appear.
3. Drag a handle up to the patch where you want to trim the chamfer piece. The chamfer piece is trimmed. Notice that Edited appears in the Pieces table for the selected piece. Repeat the process if needed.
4. To trim another chamfer piece, repeat step 2. and step 3.
5. To restore the trimmed chamfer piece to its original state, select Included from the Pieces table or on the Pieces tab shortcut menu.
6. The trimmed chamfer piece is complete. Close the Pieces tab to activate Sets mode and continue to work with chamfers.
7. When completed, click to create the chamfer and close the Chamfer tool.
 
• If you trimmed multiple pieces in the current chamfer set and want to quickly restore all of them to their original state, select All included on the Pieces tab shortcut menu.
• To quickly locate a piece on your model, place your cursor over each piece in the Pieces table, and it is dynamically highlighted in the graphics window.