Mold Design and Casting > Using the Ejector Pin Catalog > To Use the Ejector Pin Catalog
  
To Use the Ejector Pin Catalog
To Access the Ejector Pin Catalog
1. Perform one of these operations:
Click Mold > Catalog.
Click Cast > Component > Catalog.
In Mold Layout, click Mold > Catalog.
The CATALOG menu appears.
2. Click Ejector Pin. The COMPONENT SET menu appears.
Typical procedure for creating a set of ejector pins
1. Create or select datum points to locate ejector pins.
2. Select an ejector pin from the catalog by defining all required parameters, or select an ejector pin from the ones that exist in the model.
3. Select the placement and orientation planes for the ejector pins.
4. Trim ejector pins as required.
5. Create clearance holes for ejector pins by specifying the cutting quilt parameters.