Creo ModelCHECK > PTC Creo Modelcheck Operating Modes > Interactive Mode Checks Using Creo ModelCheck Regenerate
  
Interactive Mode Checks Using Creo ModelCheck Regenerate
Running Interactive mode checks using ModelCHECK Regenerate is different from running in regenerate mode. In regenerate mode, Modelcheck runs each time you regenerate the model. You do not have to explicitly run ModelCheck. However when you click File > Prepare > ModelCHECK Regenerate, the model is regenerated and the following additional checks are run:
In Part Mode
Regenerates the model in the same way as when you click Utilities > Model Player > Regenerate features > Finish in Creo Parametric. This ensures that the part can be fully regenerated and, if necessary, prints warning messages in the Creo ModelCHECK report.
Verifies all instances if the part is a generic representative of a family.
Checks that all simplified representations can be regenerated.
Checks that all cross-sections can be regenerated.
 
* All the above part mode checks are run in ModelCHECK Regenerate. You cannot choose to not run any of the above checks.
In Assembly Mode
Regenerates the top-level assembly and components as selected.
Verifies all instances if the assembly is a generic representative of a family if the MCREGEN_VERIFY_FT_INSTS configuration option in the config_init.mc file is set to Y.
In Drawing Mode
Regenerates all views in Drawing mode.
Reports any missing dimensional references (set the REGEN_DIM check in the check configuration file).
Performs all the checks for Part mode if you choose to run ModelCHECK Regenerate on the drawing models.
 
* The following additional checks are performed each time you run ModelCHECK Regenerate:
REGEN_DIMS (Drawing)
REGEN_ERRS (Part, Assembly)
REGEN_SREPS (Part, Assembly)
REGEN_WRNS (Part, Assembly)
REGEN_XSEC (Part, Assembly)