ARC_CREATION enables you to create a 3D curve arc by specifying either two points,
or a point and a direction.
+-------------------------------<------------------------------------+
| |
->-(ARC_CREATION)-------+-(:WIRE_PART)-------------|select part|-----------------------------+->-
| |
| +---------<----------+ |
| | | |
+-(:THREE_POINTS)--------+--|1st position|--+ | |
| V | |
| +--|2nd position|--+ | |
| V | |
| +--|3rd position|--+ | |
| | | |
| V | |
| +--------------------+-------->-------------+
| |
+-(:TANGENT_TWO_POINTS)--+--|1st position|--+ | |
V | |
+--|2nd position|--+ | |
V | |
+--|tangent dir|---+ | |
| | |
V | |
+--------------------+-------->-------------+
This command has the following options:
- :WIRE_PART - specifies the name of the wire part to which the 3D arc
belongs.
- :THREE_POINTS - specifies the start and end points of the arc, and a
point on the arc.
- :TANGENT_TWO_POINTS - specifies the start and end points of the arc,
and the direction of the tangent at the start point
of the arc.
Use this command to add a 3D curve arc to a wire part.
CIRCLE_CREATION terminate action
CURVE_CONVERSION terminate action
CURVE_DELETION terminate action
CURVE_GATHER terminate action
CURVE_MESH terminate action
CURVE_OFFSET terminate action
CURVE_SETTINGS terminate action
SPLINE_DIALOG terminate action
STRAIGHT_CREATION terminate action