STRAIGHT_CREATION enables you to create a 3D curve straight line by specifying
either two points or a point and a direction.
+-------------------------------<------------------------------------+
| |
->-(STRAIGHT_CREATION)--+-(:WIRE_PART)-------------|select part|-----------------------------+->-
| |
| +----------<----------+ |
| | | |
+-(:TWO_POINTS)----------+--|1st position|--+ | |
| V | |
| +--|2nd position|--+ | |
| V | |
| +---------------------+-------->------------+
| |
| |
+-(:POINT_AND_DIRECTION)-----+ |
| |
+-----------<-----------+ +----------<----------+ |
| | | |
+--|start position|--+--(:TWO_PTV)--+--|1st position|--+ | |
| V | |
| +--|2nd position|--+ | |
| V | |
| +---------------------+-----+
| |
| |
| |
+--(:DIR_LEN)---|MEASURE_DIR_3D_SA|--+ |
V |
+-----|length|-----+ |
V |
+------------------------+
This command has the following options:
- :WIRE_PART - specifies the name of the wire part to which the 3D straight
line belongs.
- :TWO_POINTS - specifies the start and end points of the straight line.
- :POINT_AND_DIRECTION - specifies the start point of the straight line,
and then its direction and length in one of two ways:
- :TWO_PTV - defines the direction and length with two points.
- :DIR_LEN - calls the MEASURE_DIR_3D_SA subaction to define the direction,
and then a length must be specified.
Use this command to add a 3D curve straight line to a wire part.
MEASURE_DIR_3D_SA subaction
ARC_CREATION terminate action
CIRCLE_CREATION terminate action
CURVE_CONVERSION terminate action
CURVE_DELETION terminate action
CURVE_GATHER terminate action
CURVE_MESH terminate action
CURVE_OFFSET terminate action
CURVE_SETTINGS terminate action
SPLINE_DIALOG terminate action
![[Contents]](toc.gif)
![[Index]](index.gif)
![[Books]](books.gif)