CoCreate OneSpace Designer - Commands Reference Manual

AM_GEO_C_LINE_PARALLEL creates an infinite construction line parallel to an existing line.

Syntax

                                          +-----------------------------<--------------------------+
                                          |                                                        |
                                          |                                                        |
---->(AM_GEO_C_LINE_PARALLEL)--(:GO :OK)--+(*)---(:OWNER)---|AM_GEO_SET_DOMAIN|---(:GO :OK)--------+--+----->
                                          |                                                        |  |
                                          |                                                        |  |
                                          |     +---------------------<------------------------+   |  |
                                          |     |                                              |   |  |
                                          |     +-----<------+  +---------------<--------------+   |  |
                                          |     |            |  |                              |   |  |
                                          +-----+--|offset|--+--+--|select line|--|plus side|--+---+  |
                                          |                                                           |
                                          |                                                           |
                                          +-----|select line|-----+---|position|---+------------------+
                                                                  |                |
                                                                  +--------<-------+

                            (*) necessary when the default owner is not set

Options

• :GO :OK is necessary for setting the owner of the geometry.
• :OWNER specifies the owner of the geometry using the AM_GEO_SET_DOMAIN subaction.

Specify the line to parallel and the position for the new construction line. Alternatively, specify offsets to the existing line, select the existing line, and then indicate the positive side on which to draw the parallel construction lines.

When to use

See also