SHA_ADD_SHEET_BY_OUTLINE adds a sheet, based on a completely closed 2D profile,
to a sheet metal part.
+----------------<-----------------------+
| |
-->(SHA_ADD_SHEET_BY_OUTLINE)--+--(:SHEET_PART)--------|sheet|----------+-->
| |
+--(:WP)----------------|wp|-------------+
| |
+--(:REVERSE)----------------------------+
| |
+--(:KEEP_WP)--------+--(:ON)---+--------+
| | | |
| +--(:OFF)--+ |
| |
+--(:CHECK_SHEET)----+--(:ON)---+--------+
| | | |
| +--(:OFF)--+ |
| |
+--(:BEND_PROCESS)------|process name|---+
| |
+--(:RADIUS)---------|confirmed radius|--+
| |
+--(:RELIEF_TYPE)----|relief-type name|--+
| |
+--(:RELIEF_TOOL)----[tool id]-----------+
| |
+--(:RELIEF_DEPTH)---|confirmed depth|---+
The following options are available to add a sheet by its 2D outline.
-
:SHEET_PART - specifies the sheet metal part to add the sheet to.
-
:WP - specifies the workplane containing the outline (profile).
-
:REVERSE - reverses the extrusion direction.
-
:KEEP_WP - specifies whether or not to keep the workplane.
-
:CHECK_SHEET - specifies whether or not to check the sheet metal part.
-
:BEND_PROCESS - specifies the bend process to use.
-
:RADIUS - specifies the bend radius.
-
:RELIEF_TYPE - specifies the bend relief type.
-
:RELIEF_TOOL - specifies the relief tool.
-
:RELIEF_DEPTH -specifies the relief depth.
Use this action when designing sheet metal parts with PE/Sheet Metal.
SHA_ADD_LIP terminate action
SHA_ADD_HEM terminate action
SHA_ADD_SHEET_BY_POLYLINE terminate action
SHA_OFFSET terminate action
![[Contents]](toc.gif)
![[Index]](index.gif)
![[Books]](books.gif)