CoCreate OneSpace Designer - Commands Reference Manual

MEASURE_ANGLE_SA provides methods of measuring an angle.

Syntax

---->(MEASURE_ANGLE_SA)--+----|angle|----------------->---------------+---->
                         |                                            |
                         |                  +---------<-----------+   |
                         |                  |                     |   |
                         +--|sub1|--|sub1|--+--(:REV_FIRST_DIR)-->+   |
                                            |                     |   |
                                            +--(:REV_SECOND_DIR)->+   ^
                                            |                     |   |
                                            +--(:SWITCH_DIR)----->+   |
                                            |                     |   |
                                            +--(:COMPLEMENT)----->+   |
                                            |                         |
                                            +--(:ACCEPT)--------->----+

|sub1| subaction:

  ----->+--(:EDGE)--|edge|------>-----+---->
        |                             |
        +--(:DIR)-|MEASURE_DIR_3D_SA|-+
        |                             |
        +--(:FACE)--|face|------>-----+
        |                             |
        +--(:WP)--|workplane|--->-----+

Options

• :EDGE - specifies an edge.
• :DIR - uses the MEASURE_DIR_3D_SA subaction to specify a direction.
• :FACE - specifies a face.
• :WP - specifies a workplane.
• :REV_FIRST_DIR - reverses the direction of the first point.
• :REV_SECOND_DIR - reverses the direction of the second point.
• :SWITCH_DIR - switches the two directions entered, that is, the second direction becomes the first direction, and vice versa.
• :COMPLEMENT - specifies the complement angle.
• :ACCEPT - accepts the settings defined.

When to use

All values are displayed in the Angle Output field.

See also