CoCreate OneSpace Designer - Commands Reference Manual

BSPLINE_MOVE_CURVE_POINT terminate action

BSPLINE_MOVE_CURVE_POINT moves any point on an existing B-spline curve.

Syntax


 ---->(BSPLINE_MOVE_CURVE_POINT)----|B-spline|----+
                                                  |
     +-----------------------<--------------------+
     |
     |  +--------------------<---------------------+
     |  |                                          |
     +--+--|pos|----+-->-|new pos|----+----->------+---->
                    |                 v            |
                    v   +-------------+            ^
                    |   |                          |
                    |   |   +-----------<----------+---<---+
                    |   |   |                              |
                    +---+---+---(:TANGENT)---+--|angle|->--+
                                             |             |
                                             +--|pos|--->--+

Options

The following option is available to move your B-spline points.

:TANGENT - specifies a tangent for the curve point.

When to use

Use this action to move the location of B-spline curve points in the active workplane.

Note that any modification to an existing B-spline curve point may have an effect on the whole curve.

Example

The following parameter sequence moves 2 existing B-spline points.