CoCreate OneSpace Designer - Commands Reference Manual

OVERDRAW_2D terminate action

OVERDRAW_2D draws a series of connected lines and arcs on top of current construction geometry.

Syntax


---->(OVERDRAW_2D)--+
                    |
    +-------<-------+
    |
    |                     +----(:ON)---+
    |                     |            |
    +----(:GEOMETRY)--->--+----(:OFF)--+-->-+
    |                                       |
    |                     +----(:ON)---+    |
    |                     |            |    |
    +----(:CONSTRUCTION)--+----(:OFF)--+-->-+
    |                                       |
    |                     +----(:ON)---+    |
    |                     |            |    |
    +----(:INTERSECTION)--+----(:OFF)--+-->-+
    |                                       |
    +-------------------<-------------------+
    |
    |                  +---------<----------+
    |                  |                    |
    +---|Start point|--+--|contour|------->-+---->(:OK)
                       |                    |
                       +--(:BACK)--------->-+

Options

The following options are available to define your overdrawing contour.

:GEOMETRY - selects or deselects real geometry.
:CONSTRUCTION - selects or deselects construction geometry.
:INTERSECTION - chooses whether or not you stop at an intersection point.
:ON - activates the :GEOMETRY, :CONSTRUCTION, or :INTERSECTION mode.
:OFF - de-activates the :GEOMETRY, :CONSTRUCTION, or :INTERSECTION mode.
:BACK - if an automatic contour was created, it is undone. Otherwise, the last segment created is removed.

When to use

Use this action to use existing construction geometry as a template for creating elements.

Example

The following parameter sequence assumes that you have already created the construction geometry you want to follow.

OVERDRAW_2D :GEOMETRY :ON :INTERSECTION :ON [specify start point] [specify contour points] [specify end point]