CoCreate OneSpace Designer - Commands Reference Manual

L3D_RADIUS terminate action

L3D_RADIUS dimensions any radius in the active viewport.

Syntax


---->(L3D_RADIUS)---+
                    |
+----------<--------+
|
| +--------------------------<----------------------------+
| |                                                       |
+-+------->------+-|ref_elem|-+------>-------+-|position|-+---->
  |              |            |              |
  +-(:qualifier)-+            +-(:qualifier)-+

The following syntax diagram shows the options and qualifiers available.


                   +--------------------------<----------------------------+
                   |                                                       |
-->(:qualifier)--->+---(:DIM_TEXT)------|enter the dim'n text submenu|---->+---->
                   |                                                       |
                   +---(:DIM_TEXT_END)---|exit the dim'n text submenu|---->+
                   |                                                       |
                   +---(:CLEAR_DIM_TEXT)---------------------------------->+
                   |                                                       |
                   +---(:DIM_TEXT_ON)------------------------------------->+
                   |                                                       |
                   +---(:DIM_TEXT_OFF)------------------------------------>+
                   |                                                       |
                   +---(:PREFIX)------------|prefix|---------------------->+
                   |                                                       |
                   +---(:POSTFIX)-----------|postfix|--------------------->+
                   |                                                       |
                   +---(:PLUS_TOL)----------|pm_tol|---------------------->+
                   |                                                       |
                   +---(:UPPER_TOL)---------|upper_tol|------------------->+
                   |                                                       |
                   +---(:LOWER_TOL)---------|lower_tol|------------------->+
                   |                                                       |
                   +---(:DP_POSITION)-------|POSITION_WP_SA|-------------->+
                   |                                                       |
                   +---(:DP_BY_LABEL)-------|select label|---------------->+

Options

The following options are available to help you define the radius to be measured.

:DIM_TEXT - displays the menu with which you will define your text parameters.
:DIM_TEXT_END - closes the menu you used to define your text parameters and sets the parameters.
:CLEAR_DIM_TEXT - clears the menu where you defined your text parameters.
:DIM_TEXT_ON - displays the specified dimensioning text.
:DIM_TEXT_OFF - hides the specified dimensioning text.
:PREFIX - lets you specify a prefix.
:POSTFIX - lets you specify a postfix.
:PLUS_TOL - lets you specify a plus tolerance value.
:UPPER_TOL - lets you specify an upper tolerance value.
:LOWER_TOL - lets you specify a lower tolerance value.
:DP_POSITION - repositions the display plane relative to a point you select from the display plane positioning menu.
:DP_BY_LABEL - repositions the display plane, using a specified label as a reference point.

When to use

Use this action to dimension any radius in the active viewport.

CoCreate OneSpace Designer - Commands Reference Manual

L3D_RADIUS terminate action

Syntax

Options

When to use

Example

See also