CoCreate OneSpace Designer - Commands Reference Manual

DA_SETTINGS_CONTOUR_MAP terminate action

DA_SETTINGS_CONTOUR_MAP modifies the display characteristics of the contour map in a session.

Syntax


-->DA_SETTINGS_CONTOUR_MAP---+
                             |
+----------------------------+
|
+---+--+--(:POSITION)-----+--(:RIGHT)--+--------------------+-->
    |  |                  |            |                    |
    |  |                  +--(:LEFT)---+                    |
    |  |                                                    |
    ^  +--(:TRANSP)-------+--(:TRANSPARENT)--+--------------+
    |  |                  |                  |              |
    |  |                  +--(:NOT_TRANSP)---+              |
    |  |                                                    |
    |  +--(:FRAME)--------+--(:ON)---+----------------------+
    |  |                  |          |                      |
    |  |                  +--(:OFF)--+                      |
    |  |                                                    |
    |  +--(:FRAME)--------|GET_RGB_COLOR|-------------------+
    |                                                       |
    +-------<-----------<----------<---------<-----------<--+

Options

The following options are available to configure and perform a finite element analysis of a part.

:POSITION - selects the position of the contour map.
:RIGHT - specifies the right side of the display.
:LEFT - specifies the left side of the display.
:TRANSP - selects the type of background.
:TRANSPARENT - selects a transparent background.
:NOT_TRANSP - selects a non-transparent background.
:FRAME - specifies a frame around the contour map.

When to use

Use this action when modifying the appearance of the contour map.