CoCreate OneSpace Designer - Commands Reference Manual

DA_ACCELERATION terminate action

DA_ACCELERATION applies an acceleration to a part.

Syntax


-->DA_ACCELERATION--+
                    |
+-------------------+
|
+---+--+--(:STUDY)------|SELECT S_FERRUM_STUDY|-------------+-->
    |  |                                                    |
    |  +--(:NAME)-------|string|----------------------------+
    |  |                                                    |
    |  +--(:VALUE)------|acceleration|----------------------+
    |  |                                                    |
    |  +--(:COORD1)-----|acceleration|----------------------+
    ^  |                                                    |
    |  +--(:COORD2)-----|acceleration|----------------------+
    |  |                                                    |
    |  +--(:COORD3)-----|acceleration|----------------------+
    |  |                                                    |
    |  +--(:DIRECTION)--|MEASURE_DIR_3D_SA|-----------------+
    |  |                                                    |
    |  |                      +--(:GLOBAL)--------+         |
    ^  |                      |                   |         |
    |  +--(:DA_COORD_SYSTEM)--+--(:LOCAL)---------+---------+
    |  |                                                    |
    |  +--(:SEL-CS)-----|select S_WORKPLANE|----------------+
    |                                                       |
    +-------<-----------<----------<---------<-----------<--+

Options

The following options are available to configure and perform a finite element analysis of a part.

:STUDY - specifies the associated study for the acceleration.
:NAME - specifies the name of the acceleration to apply.
:VALUE - specifies an acceleration value to apply to the part.
:COORD1 - specifies the acceleration value acting on the edge along the first axis.
:COORD2 - specifies the acceleration value acting on the edge along the second axis.
:COORD3 - specifies the acceleration value acting on the edge along the third axis
:DIRECTION - enables specification of the direction of the force.
:GLOBAL - selects the global coordinate system.
:DA_COORD_SYSTEM - enables specification of the referential coordinate system.
:LOCAL - selects a local coordinate system.
:SEL-CS - specifies the reference workplane for the local and cylindrical coordinate systems.

When to use

Use this action when applying acceleration forces on a part with Design Integrity.