SHA_ADD_SHEET_BY_POLYLINE adds a sheet, based on an open 2D polygon, to a
sheet metal part.
+------------<------------------+
| |
-->(SHA_ADD_SHEET_BY_POLYLINE)--+--(:SHEET_PART)----|sheet|-----+-->
| |
+--(:WP)------------|wp|--------+
| |
+--(:SIDE)----------|point 2d|--+
| |
|--(:DISTANCE)------|distance|--+
| |
+--(:REVERSE)-------------------+
| |
+--(:KEEP_WP)----+--(:ON)---+---+
| | | |
| +--(:OFF)--+ ^
| |
+--(:CHECK_SHEET)--+--(:ON)--+--+
| | | |
| +--(:OFF)-+ ^
| |
+--(:BEND_PROCESS)--|string|----+
| |
+--(:RADIUS)--------|radius|----+
| |
+--(:RELIEF_TYPE)---|string|----+
| |
+--(:RELIEF_TOOL)---|width|-----+
| |
+--(:RELIEF_DEPTH)--|depth|-----+
The following options are available to add a sheet by an open
2D polyline.
-
:SHEET_PART - specifies the sheet metal part to add the sheet to.
-
:WP - specifies the workplane containing the polyline.
-
:SIDE - specifies on which side of the line to add the material.
-
:DISTANCE - specifies the length/width of the sheet to add.
-
:REVERSE - reverses the extrusion direction.
-
:KEEP_WP - specifies whether or not to keep the workplane.
-
:CHECK_SHEET - specifies whether or not to check the sheet metal part.
-
:BEND_PROCESS - specifies the bend process to use.
-
:RADIUS - specifies the bend radius.
-
:RELIEF_TYPE - specifies the bend relief type.
-
:RELIEF_TOOL - specifies the relief tool.
-
:RELIEF_DEPTH - specifies the relief depth.
Use this action when designing sheet metal parts with PE/Sheet Metal.
SHA_ADD_LIP terminate action
SHA_ADD_HEM terminate action
SHA_ADD_SHEET_BY_OUTLINE terminate action
SHA_OFFSET terminate action
![[Contents]](toc.gif)
![[Index]](index.gif)
![[Books]](books.gif)