CoCreate OneSpace Designer - Commands Reference Manual

SHA_STAMP punches a hole into a sheet metal part, places a stamp part into the hole, and unites the two. Thus creating a stamp feature.

Syntax

                +----------------<--------------------+
                |                                     |
-->(SHA_STAMP)--+--(:SHEET_PART)----|sheet|-----------+-->
                |                                     |
                +--(:WP)------------|wp|--------------+
                |                                     |
                +--(:PROCESS)-------|process name|----+
                |                                     |
                +--(:TOOL_TYPE)-----[tool type id]----+
                |                                     |
                +--(:TOOL)----------[tool id]---------+
                |                                     |
                +--(:TOOL_ANGLE)----|angle|-----------+
                |                                     |
                +--(:ADJUST_POINT)--|pt 2d|--|pt 2d|--+
                |                                     |
                +--(:POSITION_BACK)-------------------+
                |                                     |
                +--(:NEXT_BOOLEAN)--------------------+
                |                                     |
                +--(:BOOLEAN_BACK)--------------------+
                |                                     |
                +--|confirmed point 2d|---------------+

Options

• :SHEET_PART - specifies the sheet metal part to be stamped.
• :WP - specifies the workplane to be used to position the stamp tool.
• :PROCESS - specifies the stamp process to use.
• :TOOL_TYPE - specifies the stamp tool type.
• :TOOL - specifies the stamp tool.
• :TOOL_ANGLE - specifies the positioning angle for the stamp tool.
• :ADJUST_POINT - specifies a new adjust point (cursor point) for the tool.
• :POSITION_BACK - undoes the last tool positioning.
• :NEXT_BOOLEAN - performs the stamp and allows to position the tool again.
• :BOOLEAN_BACK - undoes the last stamp.

When to use

Example

See also