CoCreate OneSpace Designer - Commands Reference Manual

MATE_ALIGN_PART_SA subaction

MATE_ALIGN_PART_SA specifies two faces which can be mated or aligned.

Syntax


---->(MATE_ALIGN_PART_SA)----+
                             |
+--------------<-------------+
|
+------------------------------<---------------------------------+
|                                                                |
+-(:MATE_FACES)--|move face|--|fixed face|-------------------->--+
|                                                                |
+-(:MATE_FACES_OFFSET)--|move face|--|fixed face|--|offset|--->--+
|                                                                |
+-(:ALIGN_FACES)--|move face|--|fixed face|------------------->--+
|                                                                |
+-(:ALIGN_FACES_OFFSET)--|move face|--|fixed face|--|offset|-->--+
|                                                                |
+-(:ALIGN_AXIS)--|move face|--|fixed face|--(:REVERSE)-------->--+
|                                                                |
+-(:PARALLEL_FACES)--|move face|--|fixed face|--(:REVERSE)---->--+
|
+-(:DONE)---->

Options

The following options are available to position a part.

:MATE_FACES - specifies the fixed face, and the face to be moved.
:MATE_FACES_OFFSET - specifies the fixed face, the face to be moved, and an offset value.
:ALIGN_FACES - specifies the fixed face, and the face to be aligned.
:ALIGN_FACES_OFFSET - specifies the fixed face, the face to be aligned, and an offset value.
:ALIGN_AXIS - specifies the fixed face and the face to be moved. If required, you can :REVERSE the direction of the axis.
:PARALLEL_FACES - specifies the fixed face and the face to be moved. If required, you can :REVERSE the direction of the axis.

When to use

This subaction is used to define your transformation by mating or aligning 3D parts and assemblies.

CoCreate OneSpace Designer - Commands Reference Manual

MATE_ALIGN_PART_SA subaction

Syntax

Options

When to use

See also