CoCreate OneSpace Designer - Commands Reference Manual

CIRCLE_CREATION enables you to create a 3D curve circle by specifying three points on the circumference of the circle.

Syntax

                        +-------------------------------<------------------------------------+
                        |                                                                    |
->-(CIRCLE_CREATION)----+-(:WIRE_PART)-------------|select part|-----------------------------+->-
                        |                                                                    |
                        |                        +---------<----------+                      |
                        |                        |                    |                      |
                        +-(:THREE_POINTS)--------+--|1st position|--+ |                      |
                                                                    V |                      |
                                                 +--|2nd position|--+ |                      |
                                                                    V |                      |
                                                 +--|3rd position|--+ |                      |
                                                 |                    |                      |
                                                 V                    |                      |
                                                 +--------------------+-------->-------------+

Options

• :WIRE_PART - specifies the name of the wire part to which the 3D circle belongs.
• :THREE_POINTS - specifies three points on the circumference of the 3D circle. point on the arc.

When to use

See also