Recipe Setting Name
|
Values
|
Description
|
||
---|---|---|---|---|
Creo Parametric Command
|
||||
Drawing Output
|
HPGL
CGM
DWG
DXF
PDF
|
Select the desired drawing output format. Default is HPGL.
|
||
Creo Parametric Plotter
|
HPGL plotter name. Valid for HPGL format only.
|
|||
Drawing Size
|
As Defined in Creo Parametric
|
Creates drawing of sheet size as specified in Creo Parametric.
Valid for HPGL format only.
|
||
Fixed Below
|
Creates drawing of sheet size as specified in Drawing X Size and Drawing Y Size below.
|
|||
Drawing X Size
|
Width of sheet in inches. Valid for HPGL only.
|
|||
Drawing Y Size
|
Height of sheet in inches. Valid for HPGL only.
|
|||
Conversion Mode
|
Full
|
Creates a separate OL file for each instance of a component.
|
||
Component
|
Creates a single OL file for all instances.
|
|||
Minimum Memory
|
Controls the amount of memory used by the adapter.
Loads one 3D model file at a time, processes it and then unloads it from memory before processing the next file. All instances share a single OL file in this mode too.
|
|||
Angle Dimension Unit
|
Creo Parametric Config
Degree
Degree-Minute
Degree-Minute-Second
|
Select the angle dimension unit option to convert.
Default is Creo Parametric Config (Converts as in Creo Parametric.)
|
||
Regenerate
|
Drawings
|
Regenerate drawings before publishing
|
||
Assemblies & Parts
|
Regenerate assemblies and parts before publishing.
|
|||
Use Creo Parametric
|
Macros
|
Uses Creo Parametric menu commands to erase and close the model.
|
||
Mass Properties
|
Uses Creo Parametric to calculate mass properties for the model.
|
|||
Model
|
Geometry
|
Uses Creo Parametric tessellator to tessellate model.
|
||
Planar Annotation
|
Notes
|
Uses Creo Parametric tessellator to tessellate planar notes.
This option results in big OL files.
|
||
Other Annotations
|
Uses Creo Parametric tessellator to tessellate other planar annotations.
This option results in big OL files.
|
|||
Screen Annotation
|
Notes
|
Uses Creo Parametric tessellator to tessellate screen notes. This option results in big OL files.
|
||
Other Annotations
|
Uses Creo Parametric tessellator to tessellate other screen annotations.
This option results in big OL files.
|
|||
Texture Maps
|
Convert
|
Publishes models with textures applied. Enabled by default.
See Publishing Creo Parametric Texture Maps for more information.
|
||
Modify Texture Search Path
|
Adds the source folder path to the Creo texture search path.
|
|||
Enable
|
Restart of Worker in Creation Locale
|
If proe locale and proe file creation locale are not same, then publish will fail. Enable this option to restart worker automatically in file creation locale.
|