Installing the Creo View ECAD Adapters on UNIX

Creo View ECAD Adapters Guide > Installing and Configuring the Adapters > Installing the Creo View ECAD Adapters on UNIX

Not all of the adapters are supported on UNIX. Check the Creo View Adapters Software Matrix to verify support before you begin.

Install the adapters from the Creo View Adapters media.

1. Copy the file creoview_adapters_unix.run to the directory where you want to install the adapters. For example /opt/ptc.

2. Open the terminal, and change the directory to the location where you copied the setup file.

3. Run the installation process by typing the following command:

sh ./creoview_adapter_unix.run

To see and use advanced installation options, run the following command:

sh ./creoview_adapter_unix.run -h

4. The PTC Customer Agreement is displayed. Press the Space bar or PGDN to read the information.

5. Press Y and ENTER to accept the agreement, or press N and Enter to cancel the installation.

6. The Creo View Adapters are installed.