Prerequisites for the Creo View Adapter for STL

Creo View MCAD Adapters Guide > Configuring the Creo View Adapter for STL > Introduction to the Creo View Adapter for STL > Prerequisites for the Creo View Adapter for STL

Check the following items to ensure that your system is able to run the Creo View Adapter for STL:

• The Creo View Adapter for STL must be supported on the operating system and meet the minimum requirements as shown in the Software Matrices available at:

http://www.ptc.com/appserver/cs/doc/refdoc.jsp

• Ensure that your operating system has adequate CPU and storage systems.