To Insert Stamp Annotations
1. On the
Markup tab, in the
Annotations group, click
Stamp. The stamps gallery opens.
2. In the stamps gallery, click the stamp you want to insert and point to the model view. The pointer changes to a
stamp pointer.
4. Click where you want to place the stamp. The stamp appears in the foreground and the pointer reverts to a selection pointer. In the upper data panel
View Content list, a corresponding
Stamp entry appears.
5. To move or resize the stamp in figure window, select it to display its anchor points and then perform the following actions:
◦ Move—Drag the anchor point shown in the center of the stamp.
◦ Resize—Drag any corner or side anchor point shown on the stamp border.