The
Wrap tab consists of commands. It is used for the Wrap phase of facet modeling. Click
Points >
Wrap to open the
Wrap tab.
•
Fill Edges—Adds volume over the selected facets of the model to define sharp features that may have been blurred during the scanning operation.
•
Fill Up—Adds volume to the concave parts of the selected area of the model.
•
Fill Layer—Adds a single layer of volume to the selected area of the model.
•
Push Shallow—Removes selected triangles by propagating through the selected area, and exposes the underlying triangles.
•
Push Deep—Removes triangles by propagating through the model until the point density changes.
•
Shoot Through—Deletes triangles in a straight line throughout the selected area, in a manner similar to drilling a hole.
•
Remove Webs—Removes triangles generated in the open spaces of the original point set while creating the wrap.
◦
Inside/across box—Selects points, triangles, or facets that partially or completely lie inside the rectangular marquee.
◦
Inside polygon—Selects points, triangles, or facets that completely lie inside the polygon.
◦
Paintbrush—Selects points, triangles, or facets through which the stroke of the paintbrush traverses.
◦
Inside ellipse—Selects points, triangles, or facets that completely lie inside the elliptical marquee.
•
Select by Length—Selects facets with an edge of length greater than or equal to the specified value.
•
Return to Point Phase—Returns to the Point phase from the Wrap phase, and opens the
Points tab. Available only when you import a new set of points, and is not available when you edit an existing Facet feature.
•
Cancel—Closes the
Wrap tab without saving any changes.