Part Modeling > Engineering Features > Chamfer > Advanced Topics > Piece Management > To Address Chamfer Placement Ambiguity
  
To Address Chamfer Placement Ambiguity
1. Select the references for the chamfer and on the Model tab, click the arrow next to Chamfer, and click Edge Chamfer. The Edge Chamfer tab opens.
2. Click the Pieces tab.
3. On the Sets list, select the chamfer set that contains the chamfer pieces that you want to address. All of the chamfer pieces for the current chamfer set are listed in the Pieces table.
4. In the Pieces table, do one of the following:
◦ Exclude a chamfer piece—Select the chamfer piece to exclude and select Excluded. The chamfer piece is removed from the model.
 
* You cannot exclude all of the listed chamfer pieces.
◦ Include a chamfer piece—Select the chamfer piece to include and select Included. The chamfer piece is shown on the model.
 
* All chamfer pieces are included by default.
5. To exclude another chamfer piece in the current chamfer set, repeat step 4.
6. To include an excluded chamfer piece, repeat step 4.
7. At this point, the ambiguity for the current chamfer set has been addressed. Do one of the following:
◦ In the Sets list, select another chamfer set that contains ambiguity to address.
◦ Close the Pieces tab to activate Sets mode and continue working with chamfer sets.
◦ Click to save your changes, create the chamfer, and close the Chamfer tool.
 
• You can also use Excluded or Included on the Pieces tab shortcut menu.
• If you excluded multiple pieces in the current chamfer set and want to quickly include them all, select All included from the Pieces tab shortcut menu.
• To quickly locate a piece on your model, place your cursor over each piece in the Pieces table and it is dynamically highlighted in the graphics window.