• If you are using edge references, the edge references must share a common surface. The system converts two round pieces within a round set to create the Full round.

• If you are using two surface references, you must select a third surface as the Driving Surface. This surface determines the location and sometimes the size of the round. The system replaces this common surface with a radius to create the surface-to-surface Full round.

• You can create a Full round for solid or surface geometry.

• You cannot create a Full round if:

◦ More than two edge references border the same surface.

◦ The round you are defining has a Conic cross section shape.

◦ The round you are defining has been created using a Normal to Spine creation method.