Mold Design and Casting > Working with Volumes > Redefining Volumes > Transforming Volumes > To Transform Volumes
  
To Transform Volumes
1. Perform one of the following steps:
Click Mold > Mold Volume. The Edit Mold Volume tab opens.
Click Cast > Die Volume. The Edit Die Volume tab opens.
2. Create a volume. Alternatively, you can redefine an existing volume.
3. Perform any of the following steps to transform the volume:
Use the Move or Offset command to move or offset a surface of a volume, respectively.
Use the Modify Analytic command to modify the base dimensions that drive the analytic surface of a volume.
Use the Substitute command to substitute or replace a quilt with another quilt.
Use the Edit Round or Edit Chamfer command to modify the rounds or chamfers, respectively.
4. Click OK.