To Select Loops On Surfaces in 2-Axis Trajectory Milling
Perform the following steps while creating a 2-Axis trajectory milling sequence.
1. On the References tab, click the Machining References collector and select Loops on surfaces. The Surfaces collector gets activated.
The Loops on surfaces option is available when you set the value of the configuration option enable_2x_traj_multi_loops to yes.
2. Click in the Surfaces collector and select surfaces for collection of loops.
3. In the Machining References collector, select multiple chains forming a closed loop or a closed loop of surfaces.
4. If required, select Flip Direction to change the direction of machining.
5. Select the following options as applicable:
◦ Offset Cut
◦ 
Material To Remove.
◦ Start Height
◦ Height
6. Click
.