Example: Rough, Finish, and Detach Cut Motions
The following two illustrations show an example of creating multiple Rough cut motions within the same NC sequence and then cutting off the parts in a separate NC sequence referencing the previously created cut motions.
The following illustration shows multiple Rough cut motions with Approach moves, with the following parameter settings:
CUT_MOTION_CONNECT CUT_WIRE
APPROACH_MOVE YES
1. Thread point
2. Approach move
3. Rough cut motion
4. REVERSE_DIST
5. ATTACH_WIDTH
The following illustration shows Detach motions, if you create the Detach motions using the Use Prev option, and reference the NC sequence shown in the previous illustration. The APPROACH_MOVE parameter is set to NO.
1. Detach cut motion
2. ATTACH_WIDTH + REVERSE_DIST
