Creo Intelligent Fastener > Using Creo Intelligent Fastener > Appendix > Configuration Options > Screw Configuration Options
  
Screw Configuration Options
SCR_DIGITS
Default is 3.
Set the number of digits for the Screw Fastener Definition dialog box.
SCR_SUPPRESS_NEW
Default is no.
yes—Suppress screw connections after assembling.
no—Do not suppress screw connections after assembling.
CHECKSCREW_SHOWALL
Default is yes.
yes—Show all screw connections in the Check Screw Fasteners dialog box.
no—Show incorrect screw connections only in the Check Screw Fasteners dialog box.
SCR_COLOR_THREAD
Color of the tapping drill hole.
SCR_COLOR_HOLE
Color of the clearance hole.
SCR_COLOR_CB
Color of the cylindrical counterbore.
SCR_COLOR_CON
Color of the countersink.
SCR_COLOR_PLANE
Color of the counterbore plane.
COLOR_PARTSCREW
Color of the screws.
COLOR_PARTNUT
Color of the nuts.
COLOR_PARTWASHER
Color of the washers.
COLOR_PARTINSERT
Color of the inserts.
SCR_THREAD_SERIES_COUNTERBORE
Hole chart for counterbores.
SCR_THREAD_SERIES_COUNTERSINK
Hole chart for countersinks.
SCR_THREAD_SERIES_THREAD
Hole chart for threaded holes.
SCR_THREAD_SERIES_CLEARANCE
Hole chart for clearance hole.
SCR_REPLACE_PARAM_BY_DIM_IN_NOTE
Default is no.
yes—Replace the parameter by the dimension symbol.
no—Do not modify the hole note.
SCR_REPLACE_DIAMETER
Default is no.
yes—Replace &DIAMETER[.x] by the dimension symbol.
no—Do not modify &DIAMETER[.x].
SCR_REPLACE_DRILL_DEPTH
yes, no
yes—Replace &DRILL_DEPTH[.x] by the dimension symbol.
no—Do not modify &DRILL_DEPTH[.x].
SCR_REPLACE_CBORE_DIAMETER
Default is no.
yes—Replace &CBORE_DIAMETER[.x] by the dimension symbol.
no—Do not modify &CBORE_DIAMETER[.x].
SCR_REPLACE_CBORE_DEPTH
Default is no.
yes—Replace &CBORE_DEPTH[.x] by the dimension symbol.
no—Do not modify &CBORE_DEPTH[.x].
SCR_REPLACE_CSINK_DIAMETER
Default is no.
yes—Replace &CSINK_DIAMETER[.x] by the dimension symbol.
no—Do not modify&CSINK_DIAMETER[.x].
SCR_REPLACE_CSINK_ANGLE
Default is no.
yes—Replace &CSINK_ANGLE[.x] by the dimension symbol.
no—Do not modify &CSINK_ANGLE[.x].
SCR_REPLACE_THREAD_DEPTH
Default is no.
yes—Replace &THREAD_DEPTH[.x]by the dimension symbol.
no—Do not modify &THREAD_DEPTH[.x].
CLEARANCE_HOLE_FIT_DEFAULT
Default is CLOSE.
CLOSE—Close fit for clearance hole.
FREE—Free fit for clearance hole.
MEDIUM—Medium fit for clearance hole.
CLEARANCE_HOLE_FIT_SELECT
Default is INITIAL.
INITIAL—Select CLEARANCE_HOLE_FIT_DEFAULT only on the first opening of the Screw Fastener Definition dialog box. Then always use the last setting.
ALWAYS—Select CLEARANCE_HOLE_FIT_DEFAULT always on opening the Screw Fastener Definition dialog box.
CREATE_CSYS_FOR_AUTO_UDF_CREATION
Default is no.
yes—Create a coordinate system to apply automatic UDF definition.
no—Do not create a coordinate system.