Multicomponent Mixing using a Nozzle: Exercise 7—Performing the Simulation
Simulation is performed with various options for steady and transient types.
* 
Monitoring points must be created before you perform the simulation.
1. In the Flow Analysis Tree, under Physics select Common.
2. In the Properties panel, Model tab, set values for the options as listed below:
Number of Iterations — 700
Time DefinitionSteady State Simulation
Result Saving Frequency — 100
3. In the Run group, click Run to begin the simulation. The default settings are set to Start from Initial Values and Steady in the Run group.
4. Click XYPlot Panel to view the residuals for the steady simulation.
* 
The default convergence criterion is 0.001 for steady state simulations. The calculation continues till the simulation time is reached. For better results, run it for more simulation time.
5. Click OK when the simulation is complete.
Was this helpful?