Mapped Mesh
The Mapped Mesh control option is available both in native and FEM modes.
In native mode, click Refine Model and then click the arrow next to Control. Click Mapped Mesh. The Mapped Mesh Control dialog box opens. To access the Mapped Mesh Control dialog box in FEM mode, click Home and then click the arrow next to Control. Click Mapped Mesh.
Specify the following information in the Mapped Mesh Control dialog box:
Name—Specify the name of the control or use the default name.
Meshing Regions—Specify the shape of the meshing region using the Brick, Wedge, Quad or Tri radio button in the Region Shape area. You can use points, vertices, edges, surfaces, volumes, components, mesh region edges or mesh region faces as references for creating a mapped mesh region. You can select existing datum points and vertices or points on edges or faces. Selection of points on edges or faces at a location in the entity creates a datum point at that location. You can select the entities in any order and Simulate will automatically ensure that the faces are not self-intersecting and have minimum twist.
Tip: As with all collectors, be sure to use the Ctrl key when adding entities to the collector. If you forget to do so, the already collected entities will be replaced with the newly selected entity.
When you edit an existing mesh region by removing one or many of its references, other existing mesh regions are not accessible and a new region cannot be created. Existing mesh regions become accessible only when the mesh region that is being edited is redefined correctly. If two or more edges connect two of the selected points e.g. circular edges of a cylindrical part, then there can be more than one valid region. In this case, you can pick one of the valid regions from the list.
Subdivisions—Divide the selected mesh region into triangular or quadrilateral regions.
Default—Set a default subdivision using the Default drop-down list to a value between 1 and 99. In FEM mode, the default subdivision value is 10 and in native mode it is 3. If you select a value of 5 as default subdivision then a 5X5 mapped mesh is created.
* 
You can use sim_native_mapped_mesh (for native mode subdivision) or sim_fem_mapped_mesh (for FEM mode subdivision) configuration options to set the default subdivision values.
Non-default—Select sets of meshing region edges or edge sets with consistent subdivisions to give them a subdivision value other than the default. You can select nondefault divisions edge set value 1, 2, 3, 4, 5, 10 in Native and 2, 5, 10, 20, 50,100 in FEM mode from the Subdivisions drop-down list.
1. selected edge sets shown by green thick lines
2. default subdivisions =3
3. nondefault subdivisions between two edge sets =6
Was this helpful?