Static Analysis of Models with Hyperelastic Materials
For a static analysis of a model with hyperelastic materials select the following items on the Static Analysis Definition dialog box:
Nonlinear options—If your model uses a hyperelastic material, the Nonlinear / use load histories check box is selected by default when you open the Static Analysis Definition dialog box. Hyperelasticity is highlighted in the Nonlinear options area. For an analysis of a model with hyperelastic materials, Creo Simulate always calculates large deformations. If your model has contact interfaces, Contacts is also highlighted.
Calculate large deformations—Calculates large deformations by default. You cannot clear this check box.
Constraints—Allows you to select one or more constraint sets.
Loads—Allows you to select one or more load sets unless you are using a constraint set with an enforced displacement.
You must also select items on the following tabs on the Static Analysis Definition dialog box:
Output
Was this helpful?