Manufacturing > NC Check > NC-Check > About Using NC-CHECK
About Using NC-CHECK
Optional module NC-CHECK™ allows you to display a step-by-step simulation of material removal as the tool is cutting the workpiece. This dynamic simulation process is called NCCheck.
NC Check is implemented for all types of NC sequences. If a tool model has been used, it will be replaced by the default tool of appropriate type, as defined by the tool parameter values. If a sketched tool is used, the tool display will be based on the sketch (revolved for Trajectory milling, extruded for Trajectory turning).
* 
The sketched tool’s section cannot contain splines or self-intersecting entities.
The material is removed according to the actual tool shape and motion, that is, all scallops left by the tool passes will be displayed.
* 
NC Check is not implemented for Side Mill tools.
About NC Check
To Access NC Check at the Time of Creating an NC Sequence
To Access NC Check at Any Time
To Set Up the Display
To Change a Default NC Check Color
To Store the Color Setup
To Control the Tool Display
To Change the Step Size
To Change the Resolution
To Run the CL Data
To Create or Modify a Clip Plane
To Change Image
To Refresh the Display
To Access NC Check When Editing CL Data
To Set Up Trim Planes
To Save an Image
To Restore an Image
To Use Shaded Images
Was this helpful?