Machine
• REQ_MACHINE_POWER—Specifies the amount of power necessary for an NC sequence, and can be later used in relations. The default is 0.
 |
The REQ_MACHINE_POWER parameter is inapplicable for Contouring NC sequences.
|
• TRAP_STATUS—Controls the output of the UNLOAD command to the NC sequence CL file. If TRAP_STATUS is set to ON, the UNLOAD command is output at the end of the NC sequence. The default TRAP_STATUS is OFF.
|
|
The TRAP_STATUS parameter is inapplicable for Contouring NC sequences.
|
• END_STOP_CONDITION—Specifies the stop command is issued at the end of the CL data output for an NC sequence:
• NONE (default)—No command is issued.
• OPSTOP—The OPSTOPcommand is issued.
• PROGRAM_STOP—The STOP command is issued.