Surfacing > Facet Modeling > Wrap Handling > About the Wrap Phase
About the Wrap Phase
After you have modified the point set using the Points tab, you can wrap the point set to create a triangulated model, also called a wrap, and edit the wrap to:
• Remove unwanted triangles.
• Reveal any underlying geometry.
To enter the Wrap phase, click Points > Wrap.
A wrap can consist of both closed and open surfaces that, in turn, consist of triangles, edges, and vertices.
As all the points in the point set are used to create a wrap, all the geometric information including internal structures is maintained.
To Return to the Point Phase
The Wrap Tab
Example: A Wrap Created from a Point Set
To Select Facets by Length
To Use the Push Shallow Command
To Use the Shoot Through Command
To Use the Push Deep Command
About Webs
To Remove Webs
To Fill a Concave Area by Adding Facets
To Fill an Area by Adding a Layer of Facets
To Fill an Area by Adding Facets along the Edge
About the Points Phase
About the Facets Phase
About Facet Modeling