Previous Analysis Options for Buckling Analysis
The following items appear on the Previous Analysis tab on the Buckling Analysis Definition dialog box:
• Use static analysis results from previous design study—Select this option to use results from a previously run static analysis when you include a static analysis in a buckling analysis. If this option is not selected, Creo Simulate runs the static analysis as part of the buckling analysis.
• Design Study—Select a design study to include in the buckling analysis if you selected Use static analysis results from previous design study.
• Static Analysis—Select a static analysis to include in the buckling analysis.
• Load Set—Select a load set to include in the buckling analysis. If you include a static analysis in which the Sum Load Sets checkbox is selected, you cannot select load sets to include in the buckling analysis. A combined load of all the loads in all selected load sets is used during the analysis.
• Number of Buckling Modes—Enter the number of buckling modes that you want calculated for this analysis.
 |
When you include a buckling analysis in an optimization study, Creo Simulate tracks only the first mode, since that mode will cause failure first.
|
Return to Buckling Analysis.