Output Variables

Simulation > Creo Flow Analysis > Preprocessing > Defining Physics > Turbulence > Output Variables

Output Variables

This section describes the outputs you can obtain from the Turbulence module. The following types of data are available for output from the Turbulence module:

• Primary Variables

• Properties

• Derived Variables

• Boundary Variables

• Integrated Quantities

Output of Primary Variables

Primary variables are the fundamental variables for a given set of modules and models. They are required as part of the solution.

Primary Variables for Turbulence Module
Label in GUI	Label in GUI X-Y Plot Menu	Label in points.txt	Label in integral.txt	Definition	Units	Display or Output Options
Turbulent Kinetic Energy	Turbulent Kinetic Energy	tke_	NA	Turbulent kinetic energy	J	At a Point and in the GUI Display Window
Turbulent Energy Dissipation Rate	Turbulent Energy Dissipation Rate	ted_	NA	Turbulent energy dissipation rate	J/s	At a Point and in the GUI Display Window

Output of Property Variables

Physical Properties for Turbulence Module
Label in GUI Variables	Label in GUI X-Y Plot Menu	Label in points.txt	Label in integral.txt	Definition	Units	Display or Output Options
Turbulent Viscosity	Turbulent Viscosity	muT_	NA	Effective viscosity	Pa-s	At a Point and in the GUI Display Window

Output of Derived Variables

Derived variables are engineering data computed from the primary variables. While not required as part of the solution, they can provide valuable information for analysis of the results. Nothing is currently available for the Turbulence module:

Derived Variables for Turbulence Module
Label in GUI Variables List	Label in GUI X-Y Plot Menu	Label in points.txt	Label in integral.txt	Units	Display or Output Options
NA	NA	NA	NA	-	At a Point and in the GUI Display Window

Output of Boundary Variables

Boundary variables are data associated with a boundary. While not required as part of the solution, they can provide valuable information for analysis of the results.

Nothing is currently available for the Turbulence module:

Boundary Variables for Turbulence Module
Label in GUI Results Panel Variables List	Label in GUI X-Y Plot Menu	Label in points.txt	Label in integral.txt	Definition	Units	Display or Output Options
Y Plus	NA	NA	NA	Dimensionless wall distance	NA	NA

Output of Integrated Quantities

Integrated output are quantities that you can integrate over a boundary, interface, or volume.

Integrated Values for Turbulence Module
Label in GUI Properties	Label in GUI Plot Menu	Label in integral.txt	Definition	Units	Display or Output Options
Y Plus	Y Plus	yplus	Y Plus for turbulence model	m/m	Solid Boundaries and Interfaces
Turb. Viscosity	Turbulence Viscosity	MuT	Average turbulent viscosity	Pa-s	Volumes
Turb. Kinetic Energy	Turbulent Kinetic Energy	tke	Average turbulent kinetics energy	J/kg	Volumes
Turb. Dissipation	Turbulent Energy Dissipation Rate	ted	Average turbulent dissipation	J/kg-s	Volumes
Turb. Kinetic Energy (volume)	tke_mass_total	tke_m_tot	Total turbulent kinetics energy in a volume	J	Volumes