Merge Ends
Use Merge ends to close the gap that occurs when a trajectory endpoint touches the adjacent geometry, but only part of the section is in contact with the geometry.
|
Merge ends not selected:
|
Merge ends selected:
|
|---|---|
 1. Trajectory 2. Solid 3. Gap |
 1. Trajectory 2. Solid |
Merge ends is available under the following conditions:
• Solid sweep
• Constant section
• Trajectory is open (start and end points do not touch)
• Section is oriented normal to the trajectory (Normal To Trajectory is selected as the section plane control)
• Automatic is selected for the horizontal/vertical control
• Trajectory endpoint touches the adjacent geometry
• Adjacent geometry is solid
• Geometry is added to an existing body, and the end points of the trajectory coincide with the surfaces of that same body