Part Modeling > Part Modeling > Engineering Features > Lattice > To Set Lattice Display Options
To Set Lattice Display Options
You can set the defaults for the following lattice displays:
Quality of the shaded display of simplified lattice representations
To improve the quality of the shaded display of simplified lattice representations, perform one of these actions:
Set the display_lattices_in_hq configuration option to yes.
Click File > Options > Entity Display. Under Simplified lattice display settings, select the Display lattices in higher quality shading check box.
Display style for beams of simplified lattices
To display the beams of simplified lattices in shaded display style, perform one of these actions:
Set the display_thick_lattices configuration option to yes.
Click File > Options > Entity Display. Under Simplified lattice display settings, select the Display thick lattices check box.
If the number of lattice beams is large, it is recommended to disable the thicken lattice option before saving a model. This is because saving the shading information will take up a lot of disk space. The shading information will be recreated upon retrieval if the environment is set to display thickened lattices.
Display point sets on lattice open boundaries
To display point sets on lattice open boundaries in Simulation mode only, perform one of these actions:
Set the lattice_points_in_simulate_only configuration option to yes.
Click File > Options > Entity Display. Under Simplified lattice display settings, select the Display open boundary point sets in Simulation mode only check box.