To Create Ejector Pin Clearance Holes
1. Click Mold > Production Features > Ejector Pin Hole or click Cast > Ejector Pin Hole.
2. Specify the placement type by selecting one of the following from the PLACEMENT menu:
Linear—Place the reference(s) at linear offsets from two planes.
Radial—Place the reference(s) at a radial offset from an axis and at an angle from a plane.
Coaxial—Place the reference(s) coaxial to an axis.
On Point—Place the reference(s) on a datum point. Use this command to create multiple ejector pin holes as one feature.
3. Select the datum or surface placement points.
4. Specify the location and direction of the ejector pin clearance hole(s) relative to the placement plane.
5. Specify which components the ejector pin clearance hole(s) should intersect. This can be done automatically or manually.
For each intersected component, enter the diameter of the ejector pin clearance hole in that component. The system displays the default diameter value.
6. Click Intsct Parts > Done when you have selected all components that should be intersected.
7. Specify the counterbore diameter and depth. The system displays the default values.
8. Click OK. The system regenerates the ejector pin clearance hole(s) as one feature.
* 
Remember to select the axis of the ejector pin hole and not the axis of the assembly cut feature when selecting a hole for patterning or as a reference.