Model Analysis > Creo ModelCHECK > checks > M3C_CURV_CONT (Curvature Continuity)
M3C_CURV_CONT (Curvature Continuity)
Y/N/E/W
In wire geometry, GeomIntegrityCHECK measures the curvature radii in curves and curve segments. It reports the curves and curve segments where the relative difference of the radii exceeds the configuration curvature tolerance.
In surfaces, GeomIntegrityCHECK checks the curvature radii of two segments at several points along the common border. If the maximum relative curvature difference is greater than the configuration curvature tolerance, the affected segment boundary is reported.
In topologies, GeomIntegrityCHECK checks the curvature radii of two faces at several points in a common boundary curve. If the relative curvature difference exceeds the configuration curvature tolerance, the affected boundary curve is reported.
Suggested Settings:
Inter
Batch
Regen
Save
E
E
N
N