To Specify Multiple Tips for Milling and Holemaking Tools
1. Click the Offset Table tab in the Tools Setup dialog box. By default, the offset table contains one tool tip line, Tip 1, with columns for Offset Number, Offset Distance, and Comment. The Offset Number for Tip 1 is the same as the Offset Number on the Settings tabbed page. You can change the value on either page; Creo NC synchronizes the values. The Offset Distance for Tip 1 is always 0.
2. Select the Enable Multiple Tips check box.
3. Click 
to add a tool tip. Creo NC adds another tool tip line to the offset table.
to add a tool tip. Creo NC adds another tool tip line to the offset table.4. To edit the values for Offset Number, Offset Distance, and Comment, click the appropriate cell in the table and type the desired value.
5. Repeat Steps 3 and 4 to add more tool tip lines. Clicking 
removes, after confirmation, the last tool tip line in the table. If you clear the Enable Multiple Tips check box, Creo NC asks for confirmation and removes all the tool tip lines except Tip 1.
removes, after confirmation, the last tool tip line in the table. If you clear the Enable Multiple Tips check box, Creo NC asks for confirmation and removes all the tool tip lines except Tip 1.6. Click OK when finished.