Electrical Design > Harness > Flat Harness Information > Comparing Information on Flattened vs. 3D Harnesses
Comparing Information on Flattened vs. 3D Harnesses
You can use Harness Design to find what has been flattened and what has not, and the correspondence between the flat and 3D harness segments and locations. This lets you find which locations should have connectors assembled.
For a 3D harness location, the following information is available:
The type of location
The connector or component model name, Entry Port Csys, and reference designator (if available) if the type is Entry Port
For a flat harness location, the following information is available:
The type of location and feature ID for the corresponding 3D location
The connector or component model name, Entry Port Csys, and ref_des (if available) if type is Entry Port
Whether the connector or component is currently attached to the entry port (if the type is Entry Port).
Whether it was assembled to the location, or the location was fanned out to the entry port.