FROM_CABLE_REPORT_NAME

The name of the drawing report table that gives details of the start locations of the cables and wires. The information provided in the drawing report table overrides the cable and wire spool parameters and Drawing setup options.

Format: FROM_CABLE_REPORT_NAME text_string

Example: FROM_CABLE_REPORT_NAME run_from_conductor

FROM_TO_CABLE_REPORT_NAME

The name of the drawing report table that gives details of the start and end locations of the cables and wires. The information provided in the drawing report table overrides the cable and wire spool parameters and Drawing setup options.

Format: FROM_TO_CABLE_REPORT_NAME text_string

Example: FROM_TO_CABLE_REPORT_NAME run_from_to_conductor

MAX_ALLOWED_LENGTH

Defines the maximum permitted length, for example, to avoid signal degradation.

Format: MAX_ALLOWED_LENGTH value

Example: MAX_ALLOWED_LENGTH 60

MIN_ALLOWED_DIST

The minimum permitted distance between parallel conductors that avoids interference.

Format: MIN_ALLOWED_DIST value

Example: MIN_ALLOWED_DIST 2

NAME

The name specified when you create the cable. You can edit this parameter to change the cable name.

Format: NAME text_string

Example: NAME cabl

NETWIRE

The name of the net of wires that is used as a logical reference. The value of this parameter shows up for all the wires that are routed using this net.

SPOOL

The name of the spool that the cable or wire references. You can edit this parameter to modify the spool name. This is a required parameter.

Format: SPOOL text string

Example: SPOOL spll8red

TARGET_LENGTH

Sets the required length for the cable after routing is complete. Use this parameter when a cable is purchased in specific lengths or when the cable is designed to be a certain length, such as cables for radio antenna leads.

Format: TARGET_LENGTH value

Example: TARGET_LENGTH 24

TO_CABLE_REPORT_NAME

The name of the drawing report table that gives details of the end locations of the cables and wires. The information provided in the drawing report table overrides the cable and wire spool parameters and Drawing setup options.

Format: TO_CABLE_REPORT_NAME text_string

Example: TO_CABLE_REPORT_NAME run_to_conductor

USER_DEFINED

Any user-defined parameter can be added with this format.

Format: Parameter_name value

Example: VENDOR kga_electric_supply