To Use Report Parameters in Multi-Model Drawings
To create tables that display data for different models, you must first change the active model, and then create a new repeat region and type the parameters. Otherwise, the system takes data from the last active model.
Repeat regions always remember the models from which the system is extracting their values. A report parameter that you type in a repeat region on the drawing while a certain model is active reads values from that model only. The system extracts report parameter values only when you include the parameters within a repeat region. For example, if you type a set of report parameters in a table without a repeat region, the system does not read parameters from the active model until they are enclosed by a repeat region.
If the report parameter symbol "&asm.name" resides inside a table but outside of a repeat region, it can have a suffix number (for example, "&asm.name:3") to specify the assembly in a multi-model drawing from which it is reading its information. These suffix numbers always begin counting at "0."