Progettazione elettrica > Progettazione elettrica > Adding Wires > To Change the Wire Path
To Change the Wire Path
1. Click Insert > Jog. You are prompted to select the wire, highway, or rail at the position where you want to add a jog.
2. Select the position for the new jog. Diagram assumes that you are starting to sketch from the end of the original segment that is closer to the position used to select the segment.
You can create one or more jogs by selecting successive points. A jog is added at a position wherever you click. If you place additional jogs, it is like resketching that one piece of wire, with the end of the sketched section connected with a rubberbanding segment to the other end of the originally selected piece.
3. Middle-click to stop placing the jog.
* 
To delete a jog, use Edit > Remove > Jogs.
About Adding Wires
To Create a Wire Path
To Change the Active Spool
To Make New Wires Follow an Existing Wire
To Change From-To Direction
To Add a Break to a Wire
Tip: Use Grid Settings to Control Jog Points
To Rename Wires
To Change the Spool Assigned to a Wire or Cable