To Create a Drilled Hole
1. Click > . The Hole tab opens.
2. Click
Standard to create a standard hole. The standard hole options are displayed, with
Add Tapping selected by default.
3. Clear tapping options by clicking
Add Tapping. The
Hole tab layout changes, and
Clearance hole and
Drilled hole are displayed.
4. Click
Drilled to change the hole profile to drilled.
5. Select a surface on the model where you want to place the hole. The selection is highlighted. This is your placement reference.
| You can also select the placement reference before you activate the hole tool. |
6. To change the hole placement type, select a new type from the placement Type box on the Placement tab.
7. Drag the offset placement reference handles to the appropriate references to constrain the hole. As you drag each handle, the available references are highlighted as your pointer moves over them. The system automatically snaps the handle to the reference and adds them to the Offset References collector on the Placement tab.
a. Click the Placement tab, click the Hole orientation collector, and select a planar, axial, or linear reference.
b. Select either Parallel or Perpendicular from the list.
9. Select the desired hole chart in the box adjacent to
Thread type. Thread type enables you to select industry-standard hole charts (
ISO,
UNC, or
UNF).
10. Type or select a screw size in the box adjacent to
Screw size.
| If you enter a screw size that is not listed, the system selects the closest screw size. You can also drag the hole diameter handle to select a screw size. |
11. To define the hole depth, select a depth option from the Depth Options list, or drag the depth handle in the graphics window.
| To define a new depth by dragging the depth handle, or by typing or selecting a new value, you must select the Blind depth option. |
12. To add countersink to the hole:
a. Click
Countersink on the
Hole tab.
b. To define the countersink diameter or angle, click the Shape tab and type or select a new countersink diameter or countersink angle in the corresponding boxes.
13. To add counterbore to the hole:
a. Click
Counterbore on the
Hole tab.
b. To define the counterbore diameter or depth, click the Shape tab and type or select a new counterbore diameter or counterbore depth in the corresponding boxes.
14. To ensure that the entire top of the hole intersects the outside of the solid geometry, on the
Shape tab, make sure that the
Top Clearance check box is selected.
15. To select the bodies from which geometry is removed, click the Body Options tab and select an option:
◦ To cut geometry from all the bodies that the feature passes through, select All.
◦ To cut geometry from selected bodies:
1. Select Selected.
2. Click the body collector, and then select bodies from which to cut geometry.
16. Click
OK.